Market Forge Industries STM-EX Operations Instructions download pdf (Page 8)

InstallatIon

Pan Supports and Bafes

1. Locate the mounting studs on the inside of the cham-

ber. There are two rack mounting studs on each side.

Mounting Studs

Figure 4

2. Taking one pan support and positioning rack so that

the pan stop is facing the rear of the unit and the

wires are facing toward the center of the unit. The

pan stop is a piece of sheet metal welded to the rack

with a 65° bend.

3. Begin to hang the pan support by placing the rear

key-way slot onto the rear mounting stud and slide

the rack until the slot sits on the mounting stud. When

this is done correctly the front mounting stud will be in

position to place the front key-way slot. Slide the rack

down into its correct position.

Keyway Slot

Pan Stop

Figure 5

4. After installing one pan support rack correctly, you

can install the upper bafe. Position the bafe so that

the 45° bend is facing up towards the front of the unit

(see “Figure 6”). Slide the mounting tab onto the at

bend on the pan stop bracket. The bafe should now

stay in place by itself, but in a tilted state (see “Figure

7”).

Baffle

Figure 6

Figure 7

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No comments

Market Forge Industries STM-EX Operations Instructions Page 8